What a mill buys
Spinning and weaving mills mainly buy textile paper cones for yarn winding and winding cores for yarn, thread and technical textiles. Bollant winds both from recycled kraft and board made at its own Telangana mills, with adhesive from its own adhesives unit at Nacharam, so the main inputs can be traced within the company.
Fit comes first
A cone is only as good as its seat on the spindle. Three dimensions decide that: the taper angle, the overall length and the diameter at the base. Rather than measuring these yourself, name the winder make and model or post a cone that already runs well on it; Bollant matches the three figures and returns a drawing for approval before any cones are wound. A loose seat shows up as wobble at speed and a lopsided package. On delivery, mount a handful from each lot on one of your own spindles before the lot goes to the floor, check the dimensions and colour against the approved drawing, and keep a few good cones aside as the reference for future lots.
Grip between cone and yarn
The first wraps of yarn sit directly on the paper. If the surface is too smooth for the yarn and the speed, the package can slough off when it is wound or later unwound. Grip is therefore a specification line of its own: state the yarn type and winding speed and the surface is agreed with them.
Telling lots apart
Many mills code cones by colour or print so that counts, lots or shades can be sorted at a glance on a busy floor. If you use a scheme, send it with the number of codes and the quantity under each; the quotation states what can be done.
Steam, conditioning and the mill climate
Paper softens with heat and damp. Yarn that is steamed, conditioned or dyed while on the cone needs a cone built for that process, so mention it at enquiry rather than after the first trial. Between deliveries, keep cones and cores wrapped, dry and off the floor, especially through the monsoon.
Cores for thread and technical textiles
Light yarn and thread packages can run on thin-walled cores, while technical textiles may need a heavier wall and a smooth surface that will not mark the material. Specify a core for each application, with inner diameter, outer diameter and length with tolerances, crush strength from the wound weight and tension, and plain, notched or capped ends. See how to specify cores.




